4 - 10
No. 99MBC032A
4.1.2.4 Selecting and setting the function in the B3 mode
a. Setting the abnormal value elimination function (Guidance: )
Set whether to use the abnormal value elimination function.
: Does not use the abnormal value elimination function.
: Uses the abnormal value elimination function.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option toggles between and .
While the desired setup option is flashing, press
the
ENT
key. The operation automatically enters
the process for setting the automatic workpiece
detecting function.
b. Setting the automatic workpiece detecting function (Guidance: )
Set whether to use the automatic workpiece detecting function.
: Does not use the automatic workpiece detecting function.
: Performs automatic workpiece detection with the diameter detection
method.
: Performs automatic workpiece detection with the position detection
method.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option changes in the following order:
→ → . While the
desired setup option is flashing, press the
ENT
key. If (the automatic workpiece
detecting function is not used) is selected, the
operation proceeds to setting the group judgment,
otherwise it enters the process for setting the
number of scans.
c. Setting the number of scans (Guidance: )
Set the number of scans that are used for the automatic workpiece detecting function.
: Detection from 16 scans
: Detection from a single scan
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option toggles between and . While
the desired setup option is flashing, press the
ENT
key. The operation automatically enters the
process for setting the group judgment.
NOTE Even if 16 scans are specified in the position detection method, the actual detecting
operation will be performed with a single scan.
To Next Page
Loading...
