3 - 26
No. 99MBC032A
b) If a measurement is read as the setup data by pressing the
READ
key or if the entry of a
setup value is started with an arrow key and a numeric key is pressed halfway an operation
error will result. See the example above.
PROG
1. Enter the setup mode of the offset function.
The least significant digit of the existing offset value
flashes.
PROG
2. Enter the key.
PROG
3. If a numeric key is pressed at this point, an operation
error occurs, however the display does not change.
PROG
4. To enable the entry of a numeric key, press the
C
key to cancel the setup value.
Now the numeric keys are operable.
To Next Page
Loading...
