Mitutoyo QM-Height QMH-350AX - Page 50

36
3SpecicUsageApplications
No. 99MAF600B
2 While[0.000]isdisplayed,pressandhold[→]
until a beep sound is made.
» The surface plate is set as the
reference.
Tips
The measurement value and reference vary according to the type of measurement.
• Inside diameter measurement: Center of the inside diameter
• Outside diameter measurement: Center of the outside diameter
• Plane scanning measurement: Median, minimum, or maximum value
2
Measure the inside diameter of c1.
For details about measuring inside diameters,
see "2.4 Measuring the Inside Diameter"
on page 24.
» The inside diameter (measurement value) of c1 is dis-
played in the top row, and the height from the surface
platetothecenteroftheinsidediameter(di󰀨erencein
height with the set reference) is displayed in the bottom
row.
3
Measure the inside diameter of c2.
» The inside diameter (measurement value) of c2 is dis-
played in the top row, and the height from the surface
platetothecenteroftheinsidediameter(di󰀨erencein
height with the set reference) is displayed in the bottom
row.
4
Pressandhold[←]untilabeepsoundismade.
» The set reference will be cleared, and the regular condi-
tion will be restored.