Mitutoyo QM-Height QMH-350AX - Measuring Using the Registered Measurement Steps

46
3SpecicUsageApplications
No. 99MAF600B
4
Press [ENTER].
» The step registration is ready to begin (new registration).
5
Register the measurement items in the order to be measured.
1 Refer to the following and press the key for the measurement item to
beregisteredastherststep.Forexample,press[↓]toregisteratop
surface measurement ⑤.
» [5] (top surface measurement)
will be displayed, and the
blinking cursor will move to the
right.
M1 M2
④
⑤
① ② ③
Key Measurement item Number
①
Inside diameter
measurement
1
②
Outside diameter
measurement
2
③
Plane scanning
measurement
3
④
Bottom surface
measurement
4
⑤
Top surface mea-
surement
5
2 Register the subsequent measurement items in the same way as 1. » Setting the 10th step com-
pletes the registration. The
rstregisteredmeasurement
item will then be automatically
called.
Tips
Tocompletetheregistrationbeforethe10thstep,press[ENTER].Therstregisteredmeasurementitemwill
then be automatically called.
6
Press [CANCEL].
» Proceed to step 5 in "3.4.1 Measuring Using the Reg-
istered Measurement Steps" on page 46 and perform
the measurements.
3.4.1 Measuring Using the Registered Measurement Steps
1
Press [MODE] twice.
» Characters will be displayed in the bottom row of the
LCD.