Mitutoyo QM-Height QMH-350AX - Moving the Probe Unit

10
1 Before Using This Product
No. 99MAF600B
1.3.3 Moving the Probe Unit
Theprobeunitismovedbyoperatingtheprobeunitup/downwheelortheprobeneadjustmentknob.
NOTICE
In order to prevent a reduction in the product's performance, do not move the probe unit by grabbing
it.
Slowly turn the probe unit up/down wheel to prevent malfunction or damage.
●
Quickly moving the probe unit (coarse movement)
Loosen the clamp screw (①), and turn the probe unit up/down wheel. Turning it clockwise (②) will raise
the probe unit, and turning it counterclockwise (③) will lower the probe unit.
②
①
③
Tips
Whenmovingtheprobeunitlongdistances,turntheprobeunitup/downwheelwhilegrabbingtheprobene
adjustment knob (while pushed in).
●
Slowly moving the probe unit (nemovement)
Loosen the clamp screw (①),andpulloutandturntheprobeneadjustmentknob(②). Turning it clock-
wise (③) will raise the probe unit, and turning it counterclockwise (④) will lower the probe unit.
③
④
②
①
Tips
If the counter value displayed on the LCD remains the same even when the
probe unit is moved up or down, press [HOLD DATA]. If this does not release
the hold, follow the steps in "■Whenthecountervalueisheld,andthemea-
surement cannot be made" on page 58 to release the hold.