Mitutoyo QM-Height QMH-350AX - Page 68

54
3SpecicUsageApplications
No. 99MAF600B
4
Press [↑] or [↓] and select the setting for the number of digits of the measurement value to out-
put.
» If [out-d2] is selected
Setting Details
[out-d1] Outputs six digits of the measurement value. Use this setting if connecting to a
DP-1 series device that is not compatible with 8-digit outputs.
[out-d2] Outputs eight digits of the measurement value. Use this setting if connecting to a
DP-1 series device that is compatible with 8-digit outputs.
5
Press [ENTER].
» The setup is complete and the regular condition will be
restored.
If the resolution for models that support inches is set to [0.00005 in] and [out-d1] is selected at the
step 4 , you can change which six digits in the measurement are output.
By default, the lowest six digits are set to be output. For example, in [22.12345 in], [2.12345 in] will be
output.
6
Change the output to the highest six digits.
1 Press [MODE]
» Characters and icons will be displayed in the bottom row of the LCD screen.
2 Press [ZERO/ABS] to select [OUTPUT] (output setting).
3 Press[←]or[→]until[888888]isdisplayed.
4 Press[↑]or[↓]toselect[88.8888](thehighest6digits),andthenpress[ENTER].
» Setup is complete.