MLis MLB-G3002 - Table 7: Applicability of AT^SISS <Srvparmtag> Values

MLB-G3002 Terminal User Guide 47 Rev 1.1
"smSubj"
m
"smMsg"
m
"smAuth"
m
"hcContent"
o
"hcContLen"
m
"hcAgent"
o
"hcProp"
o
"user"
o
o
o
"passwd"
o
o
o
Table 7: Applicability of AT^SISS <srvParmTag> values
  
󰇛󰇜
Parameter value; type and supported content depend on related <srvParmTag>.
    
󰇛󰇜
Supported Internet service type values in <srvParmValue> for <srvParmTag> value "srvType".
Before changing the "srvType" of an existing service profile be sure that the profile is closed. To verify the
connection state of the service profile enter the read command AT^SISI. Only when <srvState>=2 is returned for
this specific service profile you can change its service type.
Socket
MLB-G3002 acting as client or server (listener) for TCP or UDP. "etx" subparameter in
URL configures Transparent mode for Socket service.
If MLB-G3002 is TCP listener at least two service profiles are required. The first socket
profile must be configured as listener. The second service profile will be dynamically
assigned when a socket connection request from a remote client is incoming. For this
purpose, one service profile must be left free (= not configured with AT^SISS). An
incoming socket connection request will be indicated by the "^SIS" URC, with the next
free <srvProfileId> shown inside the URC as parameter <urcInfoId>. The connection
request can be accepted or rejected by using the commands AT^SISO or AT^SISC and
the ID retrieved from the "^SIS".
Ftp
MLB-G3002 acting as FTP client.
Http
MLB-G3002 acting as HTTP client.
Smtp
MLB-G3002 acting as SMTP client.