MMM Group venticell 404 - Page 4

4.4.4 information on the set Parameters during oPeration of the unit............................................13
4.4.5 s
toP P
3................................................................................................................................13
4.5 Program P
4...................................................................................................................................13
4.5.1 set P
4..................................................................................................................................13
4.5.2 set the segment for t
1........................................................................................................13
4.5.2.1 set temPerature t
1 ...................................................................................................13
4.5.2.2 set the dwell time of t
1..............................................................................................14
4.5.2.3 read out of t
1
and the dwell time...............................................................................14
4.5.2.4 set the ramP at t
1.......................................................................................................14
4.5.2.5 read out of t
1
and the ramP...................................................................................14
4.5.2.6 set the fan sPeed at the temPerature t
1......................................................................14
4.5.3 set the segment for t
2.........................................................................................................14
4.5.3.1 set the temPerature t
2...................................................................................................14
4.5.3.2 set the dwell time of t
2..............................................................................................14
4.5.3.3 read out of t
2
and the dwell time...............................................................................14
4.5.3.4 set the ramP at t
2.............................................................................................................14
4.5.3.5 read out of t
2
and the ramP........................................................................................14
4.5.3.6 set cykles for P
4.............................................................................................................15
4.5.3.7 read out of cycles for P
4.......................................................................................15
4.5.3.8 set the fan sPeed at t
2....................................................................................................15
4.5.4 start P
4...............................................................................................................................15
4.5.4.1 s1 is active, temPerature is heading towards t
1.........................................................15
4.5.4.2 s2 is active, t
1
has Been reached, dwell time is running.............................................15
4.5.4.3 s3 is active, temPerature is heading towards t
2.........................................................15
4.5.4.4 s4 is active, t
2
is reached, dwell time at t
2
is running................................................16
4.5.5 information on set Parameters during oPeration of the unit...............................................16
4.5.6 stoP P
4.................................................................................................................................16
4.6 Program P
5.................................................................................................................................16
4.6.1 descriPtion of P
5
and its control.......................................................................................16
4.7 Program P
6.................................................................................................................................17
4.7.1 descriPtion of P
6................................................................................................................17
4.7.2 Programme setting...............................................................................................................18
4.7.3 Programme start.................................................................................................................19
4.7.4 Power suPPly failure...........................................................................................................19
4.7.5 automatic shifting of P
6
Programme during cycling..........................................................19
4.7.6 manual shifting of P
6
Programme Beginning - user service
64...............................................20
4.7.7 examPles of P
6
Programme setting....................................................................................20
4.7.8 summer/winter time..............................................................................................................21
4.8
measured variaBles disPlay during the Programme run.............................................................21
4.9
keyBoard Blocking.......................................................................................................................21
4.10 error messages..........................................................................................................................21
4.11 Printing the Protocol.................................................................................................................22
4.12 adjusting and function of the air flaP........................................................................................22
4.13 exchanging the door adjusting the door....................................................................................23
5 PARAMETERS OF THE UNIT..........................................................................................................24
5.1 electric connections..................................................................................................................25
6 CLEANING AND DECONTAMINATION OF THE UNIT.................................................................25
7 MAINTENANCE......................................................................................................................26