Mounting
25
05/01 AWB2700-1384GB
3
Mounting Mounting of Modules
Mounting of WINbloc eco modules is very easy, just mount the
modules on top of the pre-installed TS 35 mounting rails (see DIN /
EN 50 022).
Step 1
Mount the first base element by tilting it slightly towards you and
placing it on the mounting rail. Then tilt the base element away
from you until it clips into place.
Figure 6: Installation of the first module
a Mount
b Clip on
Step 2
Clip-on all other modules, as described in step 1.
Step 3
When a module has been mounted, an end bracket can be used to
secure the module. Clip-on an end bracket at the beginning and
end of the module row and screw them tight.
a
b
To Next Page
Loading...