Installation
70
05/01 AWB2700-1384GB
Special EMC Measures for
Particular Applications
Switching of Inductive Loads
Recommendation:
In the case of inductive loads, a protective circuit should be fitted
on the load.
Protection against Electrostatic Discharge (ESD)
In a disassembled condition electronics modules and base elements
are prone to damage caused by ESD. To avoid ESD damage, never
touch the bus connections with bare fingers.
General Wiring Notes Overview
Lines should be divided into groups (e.g. signal lines, data lines,
high-voltage lines, supply lines).
High-voltage lines and signal / data lines should always be placed
in separated channels or bundles.
Signal and data lines must always be situated as near as possible
to grounded surfaces (e.g. support bars, metal cabinet walls).
Cable Routing
Correct cable routing prevents or suppresses mutual interferences
from parallel lines.
To Next Page
Loading...