-13-
Revision 2/F3509
IMPORTANT: THIS UNIT IS NOT
WATER PROOF.
DO NOT USE A WATER JET SPRAY TO
CLEAN INTERIOR OR EXTERIOR OF
THIS UNIT.
WARNING: ALWAYS TURN THE
POWER SUPPLY OFF BEFORE
CLEANING.
EXTERIOR
Clean with a good quality stainless steel
cleaning compound. Harsh abrasive cleaners
may damage the surface.
INTERIOR
Ensure that the oven chamber is cool. Do not
use wire brushes, steel wool or other abrasive
materials. Clean the oven regularly with a
good quality oven cleaner. Take care not to
damage the fan or the tube at the right side of
the oven which controls the thermostat.
OVEN RACKS
To remove, slide out to the stop position, raise
the front edge up, and lift out.
SIDE RACKS
To remove, lift front top to disengage and
slide rack forward. To replace, slide top rear
slot in rack onto rear stud, then engage front
keyhole on front stud.
LAMP GLASS
To remove glasses, unscrew anti-clockwise.
To replace, screw in clockwise.
OVEN SEALS
To remove, hold at their centre point and pull
forward until they unclip. Remove side seals
first, then top and bottom. The seals may be
4. MAINTENANCE
washed in the sink, but take care not to cut
or damage them. To replace, ensure that
the lip is facing the oven opening. Fit the
top and bottom seals first, then the side
seals.
OVEN DOOR GLASS
Clean with conventional glass cleaners.
IMPORTANT: DO NOT OVER
TIGHTEN LAMP GLASS.
4.1 CLEANING
WARNING: ALL INSTALLATION AND SERVICE REPAIR WORK MUST BE CARRIED
OUT BY QUALIFIED PERSONS ONLY.
To Next Page
Loading...
