12
www.mopar.com
Remove the mounting hardware.
2.
COVER REMOVAL- Standard and RamBox bed installation
Fold the cover to the forward position.
1.
Remove the cover from the truck.
3.
Cleaning the top- Standard automotive soap and water with a soft sponge or cloth is recommended.
Use a shammy for drying to keep the finished polished. Wax is NOT recommended as it tends to
fill in cracks and crevices, which may affect the textured panel finish. Do NOT use any harsh
cleaners or abrasives.
Maintenance- It is recommended that you periodically check that the cover is securely attached
to the truck. Inspect the clamps and front mounting bolts to ensure they were properly installed
and have not come loose or knocked out of adjustment during operation. Covers that are used
with high frequency or that are subject to the vibrations and impact from rough roadways can cause
the cover to require adjustment.
Lubricating the latches- It is recommended that you periodically inspect and service the latches on
each panel. Clean away any excess dirt or grime and lubricate with silicone spray. Ensure that the
latches move freely in and out to properly engage the side rail and provide proper performance with
optimum security. Be careful not to overspray the cover. Wipe away any excess lubricant around
the latch location.
1.
CARE AND MAINTENANCE
2.
3.
WARRANTY
This product is warrantied to be free from defects in material and workmanship for the lesser of
3 years or 36,000 miles from the retail date of purchase. Warranty is nontransferable and
applies to the original purchaser of the bed cover product only.
The manufacturer reserves the right to determine whether a product needs to be repaired or
replaced. No labor or service allowance is given or implied. The warranty does not cover any
damage to the product caused by accident, collision, alteration, modification, customer abuse or
neglect, off-road driving, commercial use, theft, vandalism, natural disaster or loss of product or
parts. The warranty is void if the installation instructions or operating instructions are not
followed. The manufacturer assumes no liability for injury, loss, incidental or consequential
damages. The manufacturer reserves the right to substitute an entire replacement system or
provide other remedies than those listed in this warranty for discontinued products or other
reasons.
Please feel free to contact us should you require any assistance with your bed cover. Phone:
833-204-2606. Email: FCACare@truck-hero.com.
NOTE: Failure to follow these cautions may result in severe damage and will void the warranty
Do not operate the vehicle with objects on top of the cover.
Remove any snow
or foreign matter
before folding the cover.
Do NOT tow your vehicle
from the rear with this
cover on the truck.
CAUTION
K6862677
June 20, 2019
To Next Page
Loading...
