Page 25
SYSTEM
Setting the machine to operate in manual sheet feed mode
In order to feed heavy stock, very small or very large sheets, embossed or even irregular
shaped sheets, it may be necessary to feed the sheets manually.
The machine can be programmed and set up in exactly the same way as explained when
operating the machine automatically.
The machine can now be started by activating the System switch to ‘on’.
Select the icon on the touch screen and begin to feed the sheets individually onto the
feed bed.
To stop feeding the sheets, select the icon on the touch screen and switch the
System Switch off.
NOTE.
If the delay between feeding sheets is excessive, the system will time out.
AutoFold Pro
Operating the AutoFold Pro
To Next Page
Loading...
