Trouble Shooting
Page 32
Error Screens
Sheet did not arrive.
Paper Crunch
Clip 1 NOT clear (Back Sensor)
If the machine stops and error message 01 is displayed on the touch screen, this
indicates that the paper did not arrive at the end of the suck process; so the machine
timed out. Press the green tick button and then press the start button.
If the machine stops and error message 02 is displayed on the touch screen, this
indicates that a paper jam has been detected.
Press the system switch down and then select the right or left arrows, to inch the
paper forwards or backwards. See page 30 that describes how to remove paper jams.
Press the green tick button and then press the start button.
If the machine stops and error message 09 is displayed on the touch screen, this
indicates that the sensor is or was blocked when it should have been clear.
i.e. A jam in the paper path or the wrong length of paper has passed through the
sensor.
To correct - check if paper is present and check that the paper path is clear before
restarting. See page 30 that describes how to remove paper jams.
FOLDING
To Next Page
Loading...
