Moto 360 - Assembling Your Watch

12
Your 3rd gen Moto 360 comes two 20mm bands in the box;
premium leather and silicone.
The quick-release lug pins are designed for simple
removal and installation so that you can swap your strap
easily if needs be.
To install a band:
1. With the pin attached to the
band, go ahead and insert the
pin into the lug hole that’s op-
posite to the latch.
2. Slide the latch toward the
center of the band and hold it
down while inserting the other
side of the pin into the remain-
ing lug hole.
3. Tug gently to ensure the
band is firmly in place.
Tip: Make sure that the band
with the buckle (A)is placed
To replace the band: Place your watch face down on a soft cloth.
Slide the metal latch from side to side to release the metal pin
holding the band in between the watch lugs. Gently pull the band
away at an angle until it disconnects and repeat the process on
the other side. Repeat the installation process above.
21
3
Assembling Your Watch