2.10.2
Using Low Audio
When and where to use:Placing or receiving a Phone, PABX, or Duplex Private call.
NOTE: It can also be used in group mode when discrete listening is required.
Procedure:
1 Hold your radio as you would a telephone.
2 Speak into the bottom microphone and listen through the earpiece.
Keep the antenna at least 2.5 cm from your head and body.
2.11
During a Call
During the call, if the audio is routed to different setting, the following is displayed:
Table 12: During the Call
Audio Setting Displayed Notification
Audio goes to the main
speaker
Speaker HIGH
Audio goes to the earpiece
Speaker LOW
NOTE: You can change the High or Low audio setting using the OTB. See One-Touch Buttons
on page 41.
2.12
Selecting Talkgroups
Follow these procedures to select talkgroup manually. If the selected talkgroups is an InterSystem
Interface (ISI) talkgroup, your radio can migrate to another talkgroup linked network, changing the
talkgroup automatically.
Prerequisites:Talkgroups are pre-set by your service provider.
Procedure:
From the home screen, use one of the following methods:
• Toggle the Talkgroup Selector button until the required talkgroup name is displayed.
NOTE: The Talkgroup Selector only list out the talkgroups of the current folder. To view
talkgroups from other folders, see Setting Talkgroup Folders on page 72 to change
folders.
• Select Menu/OK→Favorite TGs→Select TGs. Select the required talkgroup and press
Menu/OK to confirm.
2.13
Entering TMO or DMO Mode
Prerequisites:Your service provider can enable this mode.
MN004519A01-AL
Chapter 2 : Getting Started
38
To Next Page
Loading...
