Motorola solutions ST7500 - Additional Address; Enabling or Disabling Additional Address; Selecting Additional Address

By default, targeted status messages can be sent to private or talkgroup addresses.
Your service provider can restrict valid addresses to numbers stored in Contacts.
NOTE: This feature is not supported on Dimetra networks.
4.4.7.3.1
Sending Targeted Status Messages
Procedure:
1 From the home screen, press the Menu/OK key.
2 Select Messages→Send Status.
3 Select the required status message and press the Menu/OK key.
4 Do one of the following:
• Enter the number and press and hold the Menu/OK key. Select Send.
• Select the required talkgroup from the TalkGroup List.
The display shows one of the following delivery reports:
• Status Sent
• Status Failed
4.4.8
Additional Address
The Additional Address feature allows the radio to send Radio Messaging System (RMS) messages
and Local Information Protocol (LIP) reports to additionally defined recipients.
The default addresses for the RMS messages and LIP reports are defined by your service provider.
RMS messages and LIP reports are also sent to selected and enabled additional address.
4.4.8.1
Enabling or Disabling Additional Address
Procedure:
1 From the home screen, press the Menu/OK key.
2 Select Messages→Add. Address→Enable.
3 Select one of the following options:
• To activate the feature, select On.
• To deactivate the feature, select Off.
4.4.8.2
Selecting Additional Address
Procedure:
1 From the home screen, press the Menu/OK key.
2 Select Messages→Add. Address→Select Address.
The radio displays a list of aliases.
3 Scroll to the required alias and press the Menu/OK key.
MN004519A01-AL
Chapter 4 : Main Menu
69