2 Select BT Settings→Disconnect All.
All devices are disconnected.
NOTE: To disconnect only one device, from the home screen, select Menu/OK→BT Devices,
highlight the required device, and press Menu/OK. Select Disconnect.
4.8.6
Setting Indoor Location
NOTE: Your service provider can enable this feature.
Indoor Location is used to track radio location while the radio is indoors. When Indoor Location is
activated, your radio receives beacon information from various dedicated beacons within the range of
the radio. The radio then sends the information within a Location Information Protocol message to the
Switching and Management Infrastructure, and a mapping application decodes the information to
calculate the location of the radio.
Procedure:
1 From the home screen, press the Menu/OK key.
2 Select BT Settings→Indoor Loc.
3 Select On or Off to activate or deactivate Indoor Location.
Your radio is now able to detect Bluetooth location beacons when Indoor Location is activated.
NOTE: The use of the Indoor Location feature may have a negligible impact on other Bluetooth
functions on your radio.
4.8.6.1
Viewing Detected Beacons
Prerequisites:Turn on Indoor Location. If Indoor Location is turned off, the screen displays Service
Restricted.
Procedure:
1 From the home screen, press the Menu/OK key.
2 Select BT Settings→Indoor Loc..
3 Select Beacons Found.
4 Select the preferred beacon.
The screen displays details of the beacon.
4.8.7
Connecting Firearms Devices
Prerequisites:Only pre-approved firearms devices can be used. The service provider is responsible
for configuring the radio to work with specific devices. See Add Bluetooth Devices on page 95.
When and where to use:To select a firearm sensor device for Bluetooth connection.
Procedure:
1 From the home screen, press the Menu/OK key.
2 Select BT Settings→Firearms.
MN004519A01-AL
Chapter 4 : Main Menu
77
To Next Page
Loading...
Need help?
General
