Motorola solutions ST7500 - Enabling or Disabling Location; Language; Location; Setting Default Vibrate

4.12.1
Vibrate
This sub-menu allows you to determine if your radio vibrates, or rings, or vibrates and then rings when
receiving a call.
NOTE: The vibration when pressing the capacitive Touch User Interface, known as Haptic
Feedback, is enabled by default and not controlled by this menu.
4.12.1.1
Setting Default Vibrate
Procedure:
1 From the home screen, press the Menu/OK key.
2 Select Setup→Vibrate.
3 Select one of the following options:
• Vibe then Ring
• Vibe Only
• Ring Only
4.12.2
Location
NOTE: This is a Software Selling Feature.
This sub-menu allows you to enable the GNSS.
See Global Navigation Satellite System (GNSS) Location Service on page 99.
4.12.2.1
Enabling or Disabling Location
Procedure:
1 From the home screen, press the Menu/OK key.
2 Select Setup→Location.
3 Select On or Off.
4.12.3
Language
This sub-menu allows you to change the language of the radio.
4.12.3.1
Setting Language
Prerequisites:The list of available languages is set by service provider.
Procedure:
1 From the home screen, press the Menu/OK key.
2 Select Setup→Language.
MN004519A01-AL
Chapter 4 : Main Menu
85