Motorola APX 7500 - Replacing the High Speed Board; Low Speed Board; Removing the Low Speed Board; Figure 5-7. Removing and Replacing Low Speed Board

September 9, 2011 68009482001
5-8 Maintenance: Assembly and Disassembly Procedures
5.2.6.2 Replacing the High Speed Board
1. Align the components on the High Speed Board with cutouts in the chassis.
2. Line up the holes on the High Speed Board with the standoffs on the chassis.
3. Install the six screws (A) on the High Speed Board assembly as shown in Figure 5-6 using a
T15 TORX™ driver.
4. Tighten the screws to 1.0 N-m.
5.2.7 Low Speed Board
5.2.7.1 Removing the Low Speed Board
1. Unplug the Audio Jack Connector which is attached to the chassis.
2. Remove the four screws (A) on the Low Speed Board assembly as shown in Figure 5-7 using
a T15 TORX™ driver.
3. Remove the Low Speed Board with Flex attached.
4. Store the Low Speed Board assembly in anti-static bag when it is not being serviced.
Figure 5-7. Removing and Replacing Low Speed Board
Audio Jack Connector
Screw (A)