September 9, 2011 68009482001
3-16 Installation: Programming the Consolette
Figure 3-7. Networks Parameters page
3.7.2.5 Assigning a new IP Address:
Assigning a new IP address is not necessary as long as the Consolette is not used on a Local Area
Network (LAN). However, if the Consolette is to be connected to a network, the Consolette’s network
addresses should be configured at this time.
From the Network Parameters Page (Figure 3-7), set the Consolette IP Address field to the address
assigned for the Consolette. Set the IP Netmask and Gateway IP Address fields appropriately for the
network.
It should not be necessary to change the RNDIS Default Address unless some other device must be
connected to the PC which conflicts with the default address.
Click Store to transfer the new settings to the Consolette
NOTE: The IP address can also be viewed from the Setup menu on the auxiliary display of the
Consolette.
3.7.2.6 Editing fields and applying the changes to the Consolette:
From the browser, the user can now change the selections of their Consolette controller board. First
make the changes and then to transfer the changes to the Consolette select “Store” at the bottom of
the web page.
If there are no invalid fields, the changes will be stored immediately. If there are invalid fields, the
Consolette will popup a warning to the user. One the items are corrected, select “Store” again to
commit the changes.
The “Back” button can be used to navigate between the links without committing the changes.
To Next Page
Loading...
