68009482001 September 9, 2011
Troubleshooting Charts and Error Codes Troubleshooting Charts 7-15
Figure 7-13. Audio Jack RX - A
Apply an on-channel signal at -47dBm,
modulated by a 1kHz tone at 60% rated
system deviation, to the Consolette receiver.
Is there a 1kHz,
~300mVrms tone at U1810-
6 on the Consolette
Mainboard?
Reprogram/Replace Consolette
Mainboard.
Is the APX7500 mobile
operating properly?
Refer to the APX7500
Detailed Service
Manual for correct
operation and
troubleshooting.
Is there a 1kHz,
~300mVrms tone at
R1883?
Is ~3.3Vdc
present at
U1810-2?
There may be an issue with the
internal board routing of
VCC_3.3V.
Verify R1878, U1810,
C1820, R1877, R1876 &
C1821 are placed properly.
Does U1810-1
measure ~2.8Vdc?
Replace U1810.
Reprogram/Replace Consolette
Mainboard.
No
No
No
No
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Is there a 1kHz, ~300
mVrms tone at the 3.5mm
audio jack?
STOP
Is the RX Codec Adjustment
in the Consolette Configuration
properly tuned?
Refer to the “Receive
Audio Tuning –
RX_AUDIO” section of
the manual
~300mVrms tone present
No
To Next Page
Loading...
