HLN6923A October 12, 2005
Introduction: Base/Control Stations 1-3
Figure 1-5. Remote Mount Configuration, with 110W transceiver
For details on these configurations, see Section 2.2.2 on page 2-8.
1.3 Base/Control Stations
NOTE: The base/control station option is not applicable for 110W radios.
If mobile radio equipment is installed at a fixed location and operated as a control station or as a
fixed unit, the antenna installation must comply with the following requirements in order to ensure
optimal performance and compliance with the RF energy exposure limits in the standards and
guidelines listed in the 68P81095C99 manual:
• The antenna should be mounted outside the building on the roof or a tower if at all possible.
• As with all fixed site antenna installations, it is the responsibility of the licensee to manage the
site in accordance with applicable regulatory requirements and may require additional compli-
ance actions such as site survey measurements, signage, and site access restrictions in order
to ensure that exposure limits are not exceeded.
GCAI 2. Not for Keypad Mic
GCAI 1
To Next Page
Loading...
Need help?
General