HLN6923A October 12, 2005
Standard Configurations: Radio Mounting 2-15
2.2.2.2.3.1 Transmitter Control Power Lead (Yellow)
Connect the yellow lead to the ignition switch (recommended) or directly to the battery hot supply
(see Figure 2-23).
2.2.2.2.3.2 Receiver Control Power Lead (Red)
Connect the red lead to the positive battery terminal (recommended) or the ignition switch (see
Figure 2-23).
2.2.3 Locking Kit (Optional)
2.2.3.1 All Radios Except 110W
If an optional locking kit is used (shown in Figure 2-21), position the lock bottom housing on the
trunnion before installing the radio mounting screws. Then slip the top lock housing on and remove
the key. You can install the lock on either side of the radio, and by rotating it 180°, you can also install
it on dash installations.
Figure 2-21. Locking Kit (Optional) (Cannot Be Used for 110W Radios)
Table 2-2. Fuse Assembly for Yellow and Red Leads Parts List
Motorola Part Number Description
1482882A01 Insulator, Fuseholder Body
1482883A01 Insulator, Fuseholder Cap
2900136968 Lug
2900824456 Lug, Ring Tongue
2900865065 Lug, Ring Tongue
4182885A01 Spring, Compression; Fuse
4282884Q01 Clip, Fuse
6500020404 Fuse, 3-Amp 250V (Qty. 2)
Existing
Mounting
Screw
Lock
Lock
Housing
HLN6372_ Locking Kit
To Next Page
Loading...
