What to do if Motorola Two-Way Radio is dead and display doesn't turn on?
If your Motorola Two-Way Radio is dead and the display does not turn on, the cause might be a dead battery. Replace it with a charged battery.
Why does my Motorola CP200XLS have no receive audio or receiver does not unmute?
If your Motorola Two-Way Radio has no receive audio or the receiver does not unmute, the issue may be related to programming. Ensure the transmitted signal matches the receiver configuration (PL, DPL, etc.). Also, check if the radio can be unmuted with the monitor function enabled.
How to fix distorted or not loud enough audio on Motorola CP200XLS Two-Way Radio?
If the audio on your Motorola Two-Way Radio is distorted or not loud enough, it could be due to the synthesizer not being on frequency. Check the synthesizer frequency by measuring the transmitter frequency and realign if it is off by more than ±150 Hz (VHF) or ±500 Hz (UHF).
Why is the RF sensitivity poor on my Motorola Two-Way Radio?
Poor RF sensitivity on your Motorola Two-Way Radio may be caused by several factors: * The synthesizer may not be on frequency. Check the synthesizer frequency by measuring the transmitter frequency; realign it if it is off by more than ±150 Hz (VHF) or ±500 Hz (UHF). * Another possible cause is receiver front end tuning. Check RF front-end tuning for optimum sensitivity using the tuner.
What to do if Motorola Two-Way Radio has no RF power out?
If your Motorola Two-Way Radio has no RF power output, check the Tx power level and frequency programming using the tuner.
How to resolve no modulation or distortion modulation on Motorola CP200XLS Two-Way Radio?
If you are experiencing no modulation or distortion modulation on your Motorola Two-Way Radio, check the deviation and compensation settings using the tuner.
How to fix bad microphone sensitivity on Motorola Two-Way Radio?
If you are experiencing bad microphone sensitivity on your Motorola Two-Way Radio, check deviation and compensation and realign if necessary.
What causes no or low signaling (PL, DPL, MDC) on Motorola Two-Way Radio?
If you are experiencing no or low signaling (PL, DPL, MDC) on your Motorola Two-Way Radio, check the programming.
What does EPRM ERR mean on Motorola CP200XLS and how to fix it?
An EPRM ERR on your Motorola Two-Way Radio indicates a codeplug structure mismatch, non-existence of codeplug, or an EEGROM Checksum Error where the codeplug checksum is wrong. Reprogram the codeplug with the correct codeplug and retest. If the message reoccurs, replace the main board or send the radio to a depot.
What does SYN UNLK mean on Motorola CP200XLS and how to resolve it?
A SYN UNLK error on your Motorola Two-Way Radio means that the synthesizer is unlocked. Verify the codeplug and reprogram if necessary. If the message reoccurs, replace the main board or send the radio to a depot.
General| Number of Channels | 16 |
|---|---|
| IP Rating | IP54 |
| Operating Temperature | -30°C to +60°C |
| Audio Output | 500 mW |
| Frequency Range | 136-174 MHz |
| Power Output | 1-5 W |
| Weight | Approx. 350g (with battery) |
| Power Supply | 7.5V (battery) |
To Next Page
