68009328001-A December, 2009
Full Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General 6-9
6.4.2 Radio Re-assembly - Detailed
6.4.2.1 Dust Cover Re-assembly
1. Insert the tail of the dust cap into the bottom hole of the audio jacks housing opening
(Figure 6-11).
2. Press the dust cap until the tail is fully into the hole.
3. Twist the dust cap counter-clockwise until the cap is seated properly onto the recess.
4. Press the cap again to ensure it fully covers the opening for the audio jack.
6.4.2.2 Speaker Re-assembly
1. Check that the speaker felt is in position and not damaged. If damaged replace felt.
2. Thread wires through the speaker retainer.
3. Orientate the speaker into the housing so that the wires point at approximately a 10 o’clock direc-
tion (Figure 6-12).
Note:
Make sure the dust cap is placed between the keypad retainer mounting post and the side
wall of the radio.
Figure 6-11. Dust Cap Re-assembly
Figure 6-12. Speaker Re-assembly
12 34
Wires orientated at
10 o’clock direction
To Next Page
Loading...
