Motorola HT 1000 Series - SECTION V. RADIO ALIGNMENT PROCEDURE; General

11
SECTION V. RADIO ALIGNMENT PROCEDURE
A. General
An IBM PC (personal computer) and RSS (Radio
Service Software) are required to align the radio. Refer
to the applicable RSS manual for installation and setup
procedures for the software. To perform the alignment
procedures, the radio must be connected to the PC, RIB
(radio interface box), and Universal Test Set as shown
in Figure 40-1.
BNC
RIB
RLN-4008B
RIB POWER SUPPLY
01-80357A57 (120V)
COMPUTER INTERFACE
CABLE
30-80369B71
30-80369B72 (IBM "AT" ONLY)
DATA
BUSY
GND
COMPUTER
AUDIO GENERATOR
SINAD METER
AC VOLTMETER
TX
RX
30 dB PAD
30 dB PAD
RF GENERATOR
SERVICE MONITOR
OR COUNTER
WATTMETER
TRANSMIT
RECEIVE
TEST BOX
RTX-4005B
RADIO
PROGRAM/TEST CABLE
RKN-4035A
AUDIO IN
SET TO APPROX. 800mV FOR TX
MEASURE 80mV AT THE
AC/DC METER PORT FOR TX
SMA-BNC
58-80348B33
S1347D
POWER
SUPPLY
BATTERY
ELIMINATOR
RLN-1014A
Figure 40-1. Radio Alignment Test Setup
MAEPF-22856-B