Getting Started 1 - 9
Spare Battery Charging
There are three accessories that can be used to charge a spare battery:
•
Single Slot Serial/USB Cradle
•
Four Slot Spare Battery Charger
•
UBC Adapter.
To charge a spare battery:
1. Connect the charging accessory to the appropriate power source. See Chapter 4, Accessories for setup
instructions.
2. Insert the spare battery into the spare battery charging slot and gently press down on the battery to ensure
proper contact.
The battery starts to charge automatically. The amber charge LED Indicator lights to indicate the charge status.
See Chapter 4, Accessories for charging indications. The Standard Battery usually fully charges in less than four
hours and the Extended Life Battery usually fully charges in less than six hours.
Stylus
Use the stylus for selecting items and entering information on the screen. The stylus functions as a pen and a
mouse. Tap the touch screen once with the stylus to select options and open menu items.
To remove the stylus, slide the stylus out of the stylus holder. To store the stylus, push the stylus back into the
stylus holder.
Starting the Mobile Computer
On 28, 38 and 48-key keypad configurations, press the Power button to turn on the mobile computer. On 20-key
keypad configurations, simultaneously press the Fn and MENU buttons to turn on the mobile computer. If the
mobile computer does not power on, perform a cold boot. See Resetting the Mobile Computer on page 2-34.
When the mobile computer is powered on for the first time, it initializes. The Splash screen appears for a short
period of time, followed by the Calibration screen.
Figure 1-7
Splash Screen
To Next Page
Loading...
Need help?
General