4.6
Turning the Device On
Procedure:
Rotate the On/Off/Volume Control knob clockwise until you hear a click.
Figure 7: Turning the Device On
Result:
When your device is turned on, you hear audible beep and the device vibrates depending on the Function
Switch programming.
NOTE: Ensure that your battery is properly charged and attached. If your device fails to turn on after
repeating a few times, contact your dealer.
4.7
Turning the Device Off
Procedure:
Rotate the On/Off/Volume Control knob counterclockwise beyond the white volume level indicator until
you hear a click, unless the Battery Save mode is enabled.
NOTE: Refer Device Programming Software on page 19 for more information on Battery Save
mode.
4.8
Adjusting the Volume
Procedure:
Perform one of the following actions:
● To increase the volume of the device, rotate the On/Off/Volume Control knob clockwise.
● To decrease the volume of the device, rotate the On/Off/Volume Control knob counterclockwise.
MN010351A01-AA
Chapter 4: Getting Started
17
To Next Page
Loading...
