Priority Scan
● This mode allows you to monitor traffic on two to five different frequencies.
● One frequency must be preprogrammed as a priority frequency. The other frequencies are
preprogrammed as non-priority frequencies.
● If the receiver is in the Scan mode and is monitoring the frequency activity on a non-priority frequency,
the receiver scans the priority frequency at programmed intervals. If activity is detected on the priority
frequency, the receiver locks on to that frequency. Scanning is stopped until the priority frequency
becomes inactive.
● The receiver resumes the priority scan activity. The device alerts only on the detection of alert tones
on the priority frequency. The audio turns off according to the current reset mode. Address detection is
turned off for the non-priority frequency.
NOTE: The priority frequency has monitoring precedence over the non-priority frequency.
Silent Scan
● This mode allows you to monitor traffic on two different frequencies.
● The receiver alternately scans the two frequencies and the audio remains off. When a page is detected,
the device generates a page alert and performs message storage.
● The audio turns on immediately when receiving a page after the page alert (enabling the carrier squelch
operation). The audio turns off according to the current reset mode. The receiver resumes the silent scan
activity.
NOTE: The frequencies do not have monitoring precedence over the other frequency.
Disabled
● This mode allows you to disable a Function Switch position.
● When programmed, the device plays a low frequency tone when switching the channel knob to the
Function Switch position.
5.12.2
Alert Type
This option allows you to set the type of alerts you can activate when the device is powered up or when there
is an incoming page.
The following are the three available alert types:
Tone
The device plays a tone.
Vibrate
The device vibrates.
Tone and Vibrate
The device plays a tone and vibrates simultaneously.
NOTE: The device does not alert when the device is in the amplifier charger if it is set to vibrate.
MN010351A01-AA
Chapter 5: Device Programming Software
24
To Next Page
Loading...
