6809511A13-O April 20, 2007 23
Level 1 and 2 Service Manual Disassembly
Removing and Replacing the Rear Housing
1. Remove the battery cover, battery, and SIM as described in the procedures.
2. Using a Torx driver with a T-6 bit, remove the screws at each side of the phone.
Retain the screws for reassembly. See Figure 6.
G
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
G
In addition to 2 screws, the rear housing assembly is fastened with plastic latches.
These are fragile and should be released with care.
070586o
Figure 6. Removing the Rear Housing Screws
Housing Screw
Housing Screw
To Next Page
Loading...
