6809511A13-O April 20, 2007 29
Level 1 and 2 Service Manual Disassembly
Removing and Replacing the Flip Assembly Cover
1. Remove the battery cover, battery, SIM, rear housing, antenna, and
transceiver board assembly as described in the procedures.
2. Remove the 4 flip assembly screw caps.
3. Use the T-5 driver to remove the 4 screws from the flip assembly (see
Figure 12). Retain the screws for re-assembly.
4. Before removing the flip cover, note the locations of the smart buttons on the
sides of the flip assembly.
070593o
Figure 12. Removing the Flip Assembly Screws
To Next Page
Loading...
