43
• The terminal sounds a tone as explained in the note below.
• To block reception of a Group Call, select Optns then
Block. Powering off/on the terminal unblocks the reception
of this Group Call.
Receiving a Group Call during an On-going Group Call
Depending on how the Service Provider has configured
incoming calls, the incoming call will either be:
• Forced upon you and will interrupt the on-going call (if the
incoming call has higher priority than the on-going call).
OR
• Presented to you (if it has higher
priority than the on-going call).
• To accept the call, press
Join.
• To cancel the call, press End.
Receiving an Emergency Group Call
For detailed information, see page 28.
Receiving a Broadcast Call
For detailed information, see page 29.
• When receiving a High Priority Group Call, you will hear a
“High Priority Group Call” tone (if configured by your Service
Provider).
• When receiving a Group Call from your scan list, which is not
from a high priority group, you will hear a “New Group Call”
tone (if configured by your Service Provider).
Group In Use
ID:David
TG4
End
Join
To Next Page
Loading...
