PROGRAMMING THE RADIO MTP700/MTP750 Portable Radios / Basic Service Manual 4 - 1
CHAPTER 4
PROGRAMMING THE RADIO
Before Using the Customer Programming Software (CPS)
Before you begin programming, ensure the following:
1. Install the Customer Programming Software (CPS), FVN5051A, in your computer.
2. Use a fully charged radio battery.
3. With the radio initially turned off, properly place radio into Programming Stand,
PMLN4510.
4. Connect the Programming/Data cable, FLN9636, according to Setup for Radio Pro-
gramming Figure 4-1. This cable has a switch with two positions “Data” and “Flash”.
Set the switch to “Flash” to enable programming.
5. Turn radio on by rotating the On/Off knob clockwise. Verify that no display appears
on the radio LCD screen.
Figure 4-1 Setup for Radio Programming.
MTP700/MTP750 Radio
Programming Stand
(PMLN4510)
To Computer
Serial Port
(COM 1/2)
Programming/Data Cable
(FLN9636)
To Next Page
Loading...
