5-8 MTP700/MTP750 Portable Radios / Basic Service Manual TEST SETUP & TESTING
RF Tests
Test Page
1. To set the radio into Test Page, perform the following sequence (feature must be
turned on in CPS i.e. “User Personal Data\Ergonomic Parameters\Feature
Flags\Test Page” checked on). When performing steps 2 thru 5, make sure that you
press the handset keys sequentially (less than a second between every consecutive
press).
2. Press the “Side Button 2” key.
3. Press the “1” key and “Menu” key.
4. Press the “2“ key and “Menu” key.
5. Press the “3“ key.
Hereafter, there is no need for quick sequence of pressing the handset keys.
Receiver Tests
Simulate Base Station (Registration)
1. Make sure radio control channel frequency (IFR “2440” = Rx 861.0125MHz) [IFR
“800” = Rx 420.0125MHz] is in List2 of radio. There are two ways to view List2:
a. via Test Page: When in Test Page, press “Down” navigation key to scroll to “Cell
Lists”, press “OK” using Right soft key. Then scroll down to “List2” and press
“OK”. Finally press “Right” navigation key and check that control channel fre-
quency is enlisted.
b. via CPS: Go to “System Parameters\Frequency List\List2”. Control channel fre-
quency should be in the list.
2. Make sure Country Code “753” [“234”] and Network Code “2361” [“75”] is pro-
grammed in the radio. There are two ways to verify this:
a. via Test Page: When in Test Page, press “Down” navigation key to scroll to
“Addresses”, press “OK” using Right soft key. Press “OK” to select “Home MNI”.
You should see “2F1/939” [“EA/4B”] which is the hexadecimal equivalent of
“753/2361” [“234/75”]. Press “Back” soft key until radio returns to normal/idle
mode.
b. via CPS: Go to “System Parameters\Address Extension”. “753” [“234”] and
“2361” [“75”] should be found in the first row (ie as “Home” network).
3. Select “Home Only” as the registration network by following this procedure. Press
“Menu” button and navigate down to “Networks”. Press “OK” using Right soft key.
Press “OK” to select “Networks Sel”. Finally, scroll to “Home Only” and press the
“Set” soft key.
4. Press “MCCH” followed by “Command Registn” soft key at the bottom of the IFR.
5. Check that registration is successful and programmed radio SSI “ITSI: ---/----
/00000100” (as example only) is displayed on the IFR “Manual Test” screen.
To Next Page
Loading...
