4 - 2 MTP700/MTP750 Portable Radios /Basic Service Manual PROGRAMMING THE RADIO
Reading Codeplug
1. Run the Customer Programming Software (CPS) on your computer.
2. Click the Toolbar “Read Phone” icon. Refer to the CPS Application Window Screen in
the CPS User Guide, Publication No. 68P02956C20. The setup enters an initializa-
tion process that takes about 20 seconds. After that, a reading process starts.
Note: While reading is in progress, the radio screen displays the following data:
A progress bar appears on the computer screen. After the reading process is fin-
ished, the radio Codeplug screen appears.
Programming Codeplug
1. On the menu bar, click “File”, “Open”.
2. Browse for the required Codeplug file and open the file (.dbf extension).
3. The Codeplug window appears on the screen.
4. Click the Toolbar “Write Phone” icon.
Note: The Codeplug is now being written into the radio. A progress bar is displayed on
the computer screen showing the writing status.
After a successful writing, the message “The Operation Was Successful” appears
on the computer screen.
5. Press the “OK” button.
To Next Page
Loading...
