Motorola MTP700 - How to Configure the IFR 2968 System Setup

TEST SETUP & TESTING MTP700/MTP750 Portable Radios / Basic Service Manual 5-5
How to Configure the IFR 2968 System Setup
The setup depends on the firmware version of the IFR2968, the firmware version of the
radio and the customer programming of the radio.The following steps should be taken
only as an example of how to proceed for setup.
Perform the following steps to configure the IFR 2968 System Setup with the radio set.
Note: Terms for 380-430 MHz radio in brackets [ ]:
1. Turn ON the IFR.
2. Press “Systems” mode key (wait until the digital system is initialised).
3. Press the “TETRA Mobile” soft key.
4. Press the “Set-Up” soft key and enter the System Parameters Screen.
5. Press the “Channel Plan” soft key.
6. Press “More” soft key if “TETRA 800MS” [“TETRA 410MS”] cannot be seen.
7. Press “TETRA 800MS” soft key. The “Control Channel” automatically changes to
“2440” [“800”] and “Traffic Channel” automatically changes to “2140” [“800”].
8. Press twice the “Traffic Channel” soft key and check that the marker goes to Times-
lot. Press Data key “3” followed by the “Traffic Channel” soft key, to change to Times-
lot “3”.
9. Press “Country Code” soft key. Enter “753” [“234”] and “Country Code” soft key.
10. Press “Network Code” soft key. Thereafter, enter “2361” [“75”] and press “Network
Code” soft key.
11. Press “Base Color” soft key. Thereafter, enter “1” and press “Base Color” soft key.
12. Press “Location Area” soft key. Thereafter, enter “22” [“0000”] and press “Location
Area” soft key.
13. Press “More” soft key.
14. Press “Min Rx Level” soft key. Thereafter, enter “-110dBm” and press “Min Rx Level”
soft key.
15. Press “Max Tx Level” soft key. Thereafter, enter “30dBm” and press “Max Tx Level”
soft key.
16. Press “Access Parameter” soft key. Thereafter, enter “-53dBm” and press “Access
Parameter” soft key.
17. Press “Test Mode” soft key. Press “Enable” soft key.
18. Press “Base Service” soft key.