Motorola MTP700 - Chapter 5 Test Setup & Testing; Typical Test Setup

TEST SETUP & TESTING MTP700/MTP750 Portable Radios / Basic Service Manual 5-1
CHAPTER 5
TEST SETUP & TESTING
Typical Test Setup
Before Testing
Carry out the following instructions before testing:
• Check that you have a fully charged battery (not required when using Battery Elimi-
nator). Insufficient battery supply may cause firmware or codeplug corruption during
programming.
• Connect an RF cable to the N-type RF Connector of the IFR.
• Connect the other side of the RF cable to the antenna connector on the radio using a
SMA type RF connector.
Figure 5-1 Typical Test Setup
Any level 3 repairs can deeply affect the performance of the radio and may cause a
new tuning procedure.
This tuning procedure can only be applied by cerain authorised Motorola depots
where the appropriate TEST & TUNE EQUIPMENT is available.
The appropriate TEST & TUNE EQUIPMENT is a special automated test equipment
which is only available at some Motorola factories and Motorola repair centers.
!
W A R N I N G
!
MTP700/MTP750 Radio
N-Type to BNC
N-Type
RF Connector
Battery Eliminator Cable
Power
Supply
IFR2968
SMA to BNC
0180305J49
RF Cable
Antenna Adapter Assembly
5880384G68
Battery Eliminator
Regulator 7.5V
RLN4510