4 - 4 MTP700/MTP750 Portable Radios /Basic Service Manual PROGRAMMING THE RADIO
Restoring Factory Frequencies of the Radio
To restore the factory frequencies of the radio, perform the following steps:
1. After testing your radio on the IFR, connect the setup as shown in Figure 4-1.
2. Run the CPS software on your PC.
3. In the menu bar click “Tools”, “Copy Wizard”.
• Click on “Read from a file”.
• Click on “Browse”.
• Open the file which contains the default factory frequencies (ie “default.dbf” file
which you saved in “Programming Factory” section earlier).
• Click on “Next”.
• Click on “Select All”.
• Click on “Next”.
• Click on “Write”.
• Click on “Done”.
Note: Click on toolbar “Read Phone” to check whether the same factory frequencies
were entered into the radio before programming.
Programming Firmware
Note: Login as “Administrator” to perform this task.
1. On the menu bar click “Tools”, “Write Software”.
Note: The CPS reads data from the radio. A progress bar is displayed on the computer
screen showing the reading status.
After a successful reading, the “Write Software To Phone” window appears on the
computer screen.
2. Press the “Write” button.
Note: The application is now being written into the radio. A progress bar is displayed on
the computer screen showing the writing status.
After a successful writing, the message “The Operation Was Successful” appears
on the computer screen.
3. Press the “OK” button.
4. Click the Toolbar “R” (Reset) icon to put radio into normal operating mode.
To Next Page
Loading...
