PROGRAMMING THE RADIO MTP700/MTP750 Portable Radios / Basic Service Manual 4 - 3
Programming Frequency
Carry out the following steps if you need to add or change the radio frequencies.
Note: Save your radio factory frequencies before you start programming by using “File”,
“Save As”. Give the file a proper name, eg “default.dbf”.
1. In the “Codeplug Tree” select “System Parameters”.
• Click on “Frequency List”.
• Click on “List2”.
• At the top of list, enter the three frequencies which you have selected (the following
frequencies are for example only):
Rx 420.0125MHz (IFR 800)
Rx 425.0125MHz (IFR 1000)
Rx 429.9875MHz (IFR 1199)
2. Click the Toolbar “Write Phone” icon.
3. Disconnect the radio from the programming kit.
Note: The new programmed frequencies of the radio are now available to be tested with
the IFR or for any other use.
“List2” frequencies are saved on the codeplug and may only be accessed in Test
Page mode. To go into Test Page (feature must be turned on in CPS i.e. “User
Personal Data\Ergonomic Parameters\Feature Flags\Test Page” checked on), per-
form steps 4 thru 7 by pressing the radio keys sequentially (less then a second
between every consecutive press):
4. Press the “Side Button 2” key.
5. Press the “1” key, and “Menu” key.
6. Press the “2” key, and “Menu” key.
7. Press the “3” key.
Hereafter, there is no need for quick sequence of pressing the radio keys.
8. Scroll through the list and select “Cell Lists”.
9. Press the “OK” key.
10. Scroll through the list. Select “List2”.
11. Press the “OK” key.
12. View the frequencies using the arrow navigation keys.
To Next Page
Loading...
