137
The Menu
• Check the capacity of the active scan list (number of
groups stored in the list).
•To Clear all groups from the selected scan list, press
Yes. You will be prompted to remove all groups from the
selected scan list.
• Add a group to the selected scan list. Every added
group (including a favourite group) comes with its folder,
its name or number, and its priority (if pre-programmed).
> To select a folder, scroll through the folder list. The list
does not show folders whose groups are fully used in
the selected scan list. Press Ok to select a folder.
> To select a group, scroll through the group list within
the selected folder. The list shows groups that are not
in the selected scan list. Press Ok.
> To set a priority to a group, scroll through the priority
list: high, medium, or low.
A call from a high priority group will interrupt an on-
going call with a medium and low priority.
A call from a medium priority group will interrupt an
on-going call with a low priority.
A call from a low priority group will not interrupt any
on-going call.
• Edit the scan list groups.
> Scroll to the group you wish to remove from the
selected scan list, and press Delete. You will be
prompted to remove the selected group. After a few
seconds, the display shows the updated scan list.
> To change the group priority, press Priority
. Scroll to
the selected priority and press Select.
To Next Page
Loading...
