163
Messages
Sending a Predefined Template
1. Press Send, PTT or , or the relevant one-touch numeric
key to send the message.
2. The display will show one of the following delivery reports:
• Message Delivered — to indicate that the message
was successfully sent and received.
• Message Failed — the message was not received.
3. After sending the message, your MTP850 will return to the
predefined template list or to the message editor screen.
Sending a Status Message to a Group
1. Switch to the desired talkgroup, to which you want to send
a status message.
2. From the main menu, select Messages > Send Status.
3. In this example, Lunch is the last sent
status. If you wish to send a different status,
scroll to your selection in the list of pre-
programmed statuses, or key the status
number. To stop scrolling, press Back. The
display returns to the select status list.
4. Press to view the status message.
Press Back to return to the status list.
5. Press Select, then press PTT or
, or the relevant one-
touch numeric key to send the status message.
Sending Message to a Group
You can send the message to a Group by selecting it in
address book or entering its number.
A predefined message address is also defined by your Service
Provider during programming and cannot be changed.
It is recommended to wait for the message acknowledge before
sending a new message.
Select Status
Select Back
1) Lunch
2) Dinner
3) Meeting
MENU
To Next Page
Loading...
