47
TMO Group Call
Group12, Group11,Group12 will appear during scrolling.
Change to Folder 2: Group 21, Group 22, Group 21, and
Group 22 will appear during scrolling.
In addition, your Service Provider might configure the rotary
knob as follows:
• End-Stop Rotary Knob Scrolling — the rotary knob will
stop when it reaches the last group in the folder, and a
tone will alert you that you have reached the last group in
the folder. Use the navigation key to continue scrolling
through the list.
Activating/Deactivating Scanning
See “Setting Group Scanning” on page 134.
Making a Group Call
1. From the Home display and if this is the
required group, press and hold the PTT.
2. Wait for the talk permit tone (if configured)
and then speak into the microphone.
Release the PTT button to listen.
When you start a call, all members of the
selected group who have their units turned
on, will receive the Group Call.
If you are in an on-going Group Call
and wish to make a new call,
press to ignore the current call.
Start the new call
.
The “No Group” message is displayed when you are out of the
normal coverage area of your selected group. You must then
select a new group that is valid for your working location.
Talk Group Dialing by Index - this feature is used as a speed
dial for groups. It works by pressing the Index of TG and the *
at the end.
Network 1
Folder 1
Police
Hello
Optns Contcs
Group In Use
Folder 1
TG4
Optns Folder
To Next Page
Loading...
