Motorola MTP850 - Emergency Call; Emergency Power Up during PIN Lock; Alarm Addressing

79
Emergency Operation
• If you press the Emergency button while the MTP850 is in
Emergency Mode.
• If you change group while in Emergency Mode.
The screen will show one of the following delivery reports:
• Alarm Sent
• Alarm Failed
In both cases, the screen returns within a few seconds to the
main screen of the Emergency Mode.
Due to no delivery confirmation in DMO, Alarm Sent
information confirms only sending the alarm.
Or - if configured by your Service Provider - your MTP850 will
send an Emergency Alarm:
• If you press the Emergency button without entering
Emergency Mode before.
- Other Emergency services such as starting TMO
Emergency Mode or initiating Emergency Private Call
will be unavailable.
- No visible and audio indication on sending Emergency
Alarm will be done.
Making an Emergency Group Call
To initiate or answer a call while in Emergency Mode:
• Press and hold PTT.
• Wait for the talk permit tone (if configured) and talk.
• Release PTT to listen.
For the delivery reports, see “Sending an Emergency Alarm”
above.
Some systems do not support the Emergency Alarm feature
when the user is in a “Local Area Service” area (see page 38).
High/low Audio is not making any difference to the operation in
Emergency Mode.
While in an Emergency Group Call, you can still perform group
operations (such as changing group/folder, searching for a
group, or entering the My Groups folder).