Index
IN-4 Computer Group Literature Center Web Site
I
N
D
E
X
J22 jumpers 4-8
J23 jumper 1-14
J25 serial connector 4-19
J6 connector 4-20
jumper headers
EPROM size selection (J23) 1-14
J1 (system controller selection) 1-7, 2-5
J14 (IP bus clock) 1-8, 2-5
J16 (Flash memory write protection) 2-9
J16 (SP 1 clock) 2-7
J17 (SP 2 clock) 2-7
J19 (IP bus strobe) 1-13, 2-7
J22 (SRAM backup power) 1-13, 2-7,
4-8
J23 (EPROM size selection) 2-7
J24 (Flash memory write protection) 2-7
J24 (Flash write protection) 1-15, 4-11
serial port 1 clock (J16) 1-12
serial port 2 clock (J17) 1-12
jumper headers, location of 1-5
jumpers, backplane 1-24
L
LAN
controller modules supported C-1
interface 4-16
LEDs (light-emitting diodes) 2-1, 4-20
local
bus 4-18
bus arbiter 4-19
bus timeout 4-18
resources for the processor 4-17
Local Area Network (LAN) interface 4-16
location monitors, processor 1-27
logical unit number (LUN) (see CLUN or
DLUN)
LUN (logical unit number) (see CLUN or
DLUN)
M
MC2 DRAM size switch (S3) 1-15
MC2 sector registers 1-17
MC680x0 or MC68LC0x0 MPU 4-6
MC68xx0x0 cache memory 4-6
MCECC memory model 1-16, 1-22
memory controller emulations (MC1/MC2)
1-20, 1-21
memory options 4-7
memory requirements, firmware 3-3
microprocessor options 4-6
modifying switch settings 1-22
MPU options 4-6
MVME162Bug documentation E-1
MVME162P4
as network controller C-1
board specifications A-1
cooling requirements A-2
EMC regulatory compliance A-4
features 4-1
I/O interfaces 4-12
installation 1-23
programming information E-1
regulatory compliance A-4
MVME320 disk/tape controllers D-2
MVME323 disk/tape controller D-3
MVME327A disk/tape controller D-3
MVME328 disk/tape controller D-4
MVME350 controller D-4
MVME374 network controller C-1
MVME376 network controller C-1
MVME712M installation 1-24
N
network boot process 2-11
network controller modules C-1
non-volatile RAM (NVRAM) 3-9, 3-11
no-VMEbus-interface option 4-7, 4-11, 4-18
O
operating parameters 3-9
operating temperature A-1
option fields, in firmware command 3-6
To Next Page
Loading...
