26
function of the operating system, reset your device. Be aware that resetting will
cause unsaved data to be lost.
To reset the device, press the <Ctrl+Alt+Del> keys, and select the Shut Down
option from the Windows shut down screen.
CAUTION: If the system does not respond, you can turn the device off by pressing
and holding the power button for 6 seconds or more. Be aware, this hardware power
off may damage your hard disk.
Personal Card
To insert a Personal Card into the slot:
• Pull the door latch and open the PC slot door.
• Align the card with the slot with the label side up
• Insert the card into the slot until it locks in place.
• Close the door latch
To remove a Personal Card from the slot:
• Pull the door latch and open the PC slot door.
• Click on the PC indicator on the PC Windows application.
• Highlight the name of the card and then click the Stop button.
• When prompted, press the Eject Button and pullout the card from the slot.
• Close the door latch
If you want to use the card again immediately after ejecting it, pull it out about one
inch and then push it back in.
CAUTION: Do not insert or remove a card when the MW800 is in standby mode.
Before you insert or remove a card, make sure that you exit all software applications
that access the card.
SIM Card
To insert a SIM card into the slot:
• Pull the door latch and open the PC slot door.
• Align the card with the slot with the golden SIM side up (TBD)
• Insert the card into the slot until it locks in place.
• Close the door latch
To Next Page
Loading...
Need help?
General
