MW800 User’s Guide 9
• This User’s Guide
Inspect all the items. If any item is missing or damaged, notify your Motorola
Customer Service representative immediately.
Installation and Connecting to Car Battery
Please, refer to the Mobile Workstation 800 Installation Manual and strictly follow
the installation procedure. Be aware that your device can be damaged if improperly
installed.
Turning On
Perform the following steps to turn on the MW800.
• Turn the main power switch (MAIN SWITCH) to ON. The switch is located
on the back panel of the CPU box
• Press the power button on the CPU box or the display front panel
• Wait until Windows operating system starts
NOTE: The MW800 can be configured so that the vehicle ignition switch, the power
button located on the CPU front panel, or the display power button can turn it on.
Find more details in Section 4.
CAUTION: Be aware, the CPU and the display have the same Power On scheme.
Turning Off
Use the Windows operating system Shut Down dialog box to turn off the MW800.
NOTE: The MW800 can be configured so that the vehicle ignition switch, the power
button located on the CPU front panel, or the display power button can turn it off.
Find more details in Section 4.
CAUTION: Be aware, the CPU and the display have the same Power Off scheme.
CAUTION: Remember to save important information before turning off your
workstation.
CAUTION: Never shut down your workstation by turning off the main power
switch on the back panel of the CPU box while the Operating System is working.
Doing so can damage your hard disk.
CAUTION: Be aware, that rapid turning off and on can damage your hard disk. If
you need to turn the MW800 on immediately after turning it off, always wait for the
shut down process to complete.
To Next Page
Loading...
Need help?
General
