Event Log Messages B-5
SURFboard Cable Modem Installation Manual
Code Event Log Messages Level Cable Modem Actions
I115.1
Guaranteed Min Up Stream Channel Bit
Rate configuration setting exceeds Max
Upstream Bit Rate.
4 (Error) Continue reading next bytes of Config
file. Set to Max
I115.2
Guaranteed Min Up Stream Channel Bit
Rate configuration setting out of range
I116.0
Max Upstream Channel Transmit Burst
configuration setting invalid length
4 (Error) Continue reading next bytes of Config
file. Set to 0 value
I116.1
Max Up Stream Channel Transmit Burst
configuration setting out of range
4 (Error) Continue reading next bytes of Config
file. Set to 255
I117.0
Modem Capabilities configuration setting
invalid format.
7 (Info) Continue reading next bytes of Config
file. Set to 0 value
I117.1
Modem Capabilities configuration setting. 7 (Info) No action taken
REG-RSP Registration Response
Code Event Log Messages Level Cable Modem Actions
I00.0
REG-RSP Registration Response 7 (Info) No action taken
I01.0
Registration RSP invalid format or not
recognized
4 (Error) Ignore it and continue reading next
bytes of REG-RSP msg
I02.0
Registration RSP not received. 4 (Error) Reset the board.
I03.0
Registration RSP with bad SID. 4 (Error) Continue reading next bytes of REG-
RSP msg.
I04.0
Service not available. Reason: Other
I04.1
Service not available. Reason:
Unrecognized configuration setting
I04.2
Service not available. Reason:
Temporarily unavailable
I04.3
Service not available. Reason: Permanent
UCC-REQ Upstream Channel Change Request
Code Event Log Messages Level Cable Modem Actions
C00.0
UCC-REQ Upstream Channel Change
Request
7 (Info) No action taken
C01.0
Async Msg received with invalid US
Channel ID length.
4 (Error) CM will fix to correct length, continue
parsing the channel ID value, and send
UCC-RSP to CMTS.
C02.0
UCC-REQ received unable to send UCC-
RSP, no TX opportunity.
To Next Page
Loading...
Need help?
General