Motorola SB5100 Series - UCC-RSP Upstream Channel Change Response; DHCP CM Net Configuration Download and Time of Day

B-6 Event Log Messages
SURFboard Cable Modem Installation Manual
UCC-RSP Upstream Channel Change Response
Code Event Log Messages Level Cable Modem Actions
C100.0
UCC-RSP Upstream Channel Change
Response
7 (Info) No action taken
C101.0
UCC-RSP not received on previous
channel ID.
C102.0
UCC-RSP received with invalid channel
ID.
C103.0
UCC-RSP received with invalid channel
ID on new channel.
DHCP CM Net Configuration Download and Time of Day
Code Event Log Messages Level Cable Modem Actions
D00.0
DHCP CM Net Configuration download
and Time of Day
7 (Info) No action taken
D01.0
Discover sent no Offer received, No
available DHCP Server.
4 (Error)
D02.0
Request sent, no Response. 4 (Error)
D03.0
Requested Info not supported. 4 (Error)
D03.1
DHCP response doesn't contain ALL the
valid fields as described in the RF spec
4 (Error)
D04.0
Time of Day, none set or invalid data.
D04.1
Time of Day Request sent no Response
received
5 (Warn) CM will time out in 10 secs and retry 2
nd
time. If still fails, ignore it
D04.2
Time of Day Response received but
invalid data/format.
5 (Warn) CM will time out in 10 secs and retry 2
nd
time. If still fails, ignore it
D05.0
TFTP Request sent, No Response/No
Server.
1 (Alert) CM will keep retrying 3 times. If
unsuccessful, reset the board and
acquire the same frequency.
If still failed after 3 attempts, again, reset
the board 2
nd
time and try to acquire the
2
nd
frequency in memory.
If still failed after 3 attempts, reset the
board 3
rd
time and try to scan the next
frequency in the frequency plan. The
board will eventually reboot due to
incomplete registration
Notes: To avoid repeated retrying, type
“clrscanflag” and reset the board. It will
acquire the current frequency over and
over when 3 TFTP attempts are failed
D06.0
TFTP Request Failed, configuration file
NOT FOUND.
1 (Alert)
D07.0
TFTP Failed, OUT OF ORDER packets.