Motorola Starline SG 2000 - Port Locations; Appendix A; Appendix B; Figure 2-2 Port Locations

2-2 Overview
SG 2000 Installation and Operation Manual
Port Locations
The five housing ports, shown in Figure 2-2, provide connection for coaxial cables. Note that the
housing ports are not labeled the same as the ports on the RF chassis. Side-by-side connector fittings
are limited to .750 inches at ports 1 and 2 and/or ports 3 and 4. These ports are protected by factory
inserted threaded plugs or plastic cap plugs which are discarded when the cable connectors are
installed. Port 2 is used only for connection to an external 60 Vac or 90 Vac power supply. Port 4 is
unused.
Figure 2-2 illustrates a front and end view of the housing and port locations:
Figure 2-2
Port locations
34 OUT
12IN
Port 1 Port 2
AC port Unused
Lid
Port 3 Port 4
6
3
7 8
2
1
4
5